Note: Tests to other servers are not limited.Note: Starting on NCOS release 6.6.0, the amount of available tests has been increased from 10 to 100.The remaining number of tests against a Cradlepoint server can be seen right under the Speedtest heading. This counter is permanent for the router's lifetime.

Note: Each router is allowed to run a total of 10 tests to Cradlepoint servers.If these fields are left empty, the test will be done against a Cradlepoint server. Step 4: (Optional) Enter the hostname or IP address of the netperf server you wish to perform a test to, then specify the server port.If nothing is selected, the highest priority connected WAN interface will be used. Step 3: (Optional) Select the WAN Device you want to test.

IPERF3 launch from IPERF GUI with Charts. IPERF for Windows released with Iperf3-compatible GUI and Charts. To install the port: cd /usr/ports/benchmarks/netperf/ & make install clean. Netperf is a serious networking performance evaluation tool being distributed under. Step 2: Click the SYSTEM tab and select Diagnostics.This feature will test the throughput of the router's Internet connection. Quick Links Summary Speedtest is a good tool for doing a site survey before installing a router that will be using a cellular signal. NCOS Version: 6.0.2 or later - for information on upgrading NCOS, click.

NCOS: Using Cradlepoint Speedtest Products Supported: AER31x0, AER21x0, MBR1400, MBR1200B, CBA850, CBA750B, IBR11x0, IBR6x0, IBR350.

Install Netperf On Windows